Sample metallographic equipment MP-1B new Grinding Polishing Machine sample grinding and polishing machine

MP-1B (NEW) Metallographic Grinding Polishing Machine

First,Product description:

The grinding and polishing machine adopts frequency converter speed regulation, which can make the grinding and polishing machine vary continuously change between 50-1000R/Min. By replacing the metallographic sandpaper and the polishing fabric, the grinding and polishing operations can be separately performed, so that the machine can display more wide applicability.

Second,Features and Application:

The machine has the characteristics of stable rotation, safety and reliability, compact structure and low noise, and it has a water cooling device, which can cool the sample during grinding to prevent the metallographic structure from being damaged due to overheating of the sample. The machine is convenient to use. Safe and reliable, it is the ideal sample preparation equipment for factories, research institutes and universities and colleges.

Third,Technical Parameters:

Model	MP-1B new
Diameter of working disc	φ203mm
Quantity of disc	1
Rotating speed of working disc	50-1000rpm
Power supply	220V/50HZ
Motor power	550W
Machine size (L*W*H)	730*450*370mm
Weight	36kg

Fourth,Structure Overview:

1. The grinding and polishing machine is composed of a base, a polishing disc and a plastic pressed water shield. The disc is a polishing disc. This machine adopts FRP shell, which makes the machine more beautiful and elegant in appearance.

2.The motor is fixed on the base; the shaft is driven by a V-belt; the polishing disc is sleeved on the shaft and rotated by the key; the switch is directly fixed on the housing; the flow rate of the movable spray pipe is adjusted and controlled by the knob on the panel.

Fifth,installation method:

1. Open the outer wooden box of the machine and take out the equipment.

2. Place the machine on a clean and firm platform.

3. Connect the inlet and drain pipes at the back of the machine.

4. Connect the ground wire.

5. The polishing disc is packed in a carton and placed on top of the device. When the initial installation, check whether the polishing disc is loose and install it on the center spindle of the grinding and polishing machine. If it is loose, use a rubber hammer to knock the polishing disc down to the grinding center until The polishing disc does not loose.

6. Connect the power plug to the 220V socket, turn on the power switch, start the machine according to the operation method, and check whether the operation is normal. The machine is running normally and can be used.

Packaging & Shipping